DESCRIPTION:

 SUPER BASE is designed from the best-known high-performance elastomeric specially-formulated acrylic in the market, known for adhesion, weatherability, UV-resistance, flexibility and toughness. SUPER BASE was blended to work cohesively with SUPER THERM,
to form a complete seal on any wall structure. Longevity of service was the concern, and the determination for quality was built into this base coating. It is a water-based, high-performance acrylic that is easily applied without environmental concerns, and compliments the quality of the SUPER THERM top coat. SUPER BASE was not designed to be applied to roofing structures to seal cracks. It gives the correct base
coat to seal over dry substrates to be absorbed into the surface allowing SUPER THERM to set up properly. This affords the full effect of its ceramic mixture. SUPER BASE is designed to apply to all basic walls, whether flat or inclined, in new construction or to retrofit wood, concrete, tar, sheeting, polyfoam, or sheetrock. This gives outstanding adhesion, sealing protection , flexibility, and acts as a base coat for encapsulating the surface prior to applying SUPER THERM.

APPLICATION METHODS:

 Surfaces must be clean and dry before application. Loose or flaking old paints or corrosion must be removed from surface before applying. High-pressure water-blasting (3500 psi) will remove most loose and flaking materials. If oils are present, use our SP-WB Cleaner in water according to recommended proportions to remove any oil residues. As a rule, "a coating is only as good as the surface it covers." Grease, oil, waxy substances, dirt, etc. must be cleaned from surfaces. Oil paints can remain if bonded solidly to surfaces. SUPER BASE can be applied best by airless or air pot spray, roller and by brush. If rolling, it may take two coats to attain required mils. For walls, whether underside or interior/exterior walls, SUPER BASE is applied to seal and fill hairline cracks, and seal porous wood, concrete, or wall board before SUPER THERM is applied to insulate. SUPER BASE used with
SUPER THERM gives insulation value to the roofing and walls
structures to prevent heat buildup under the roof or inside the wall areas. 

IMPORTANT:

 Do not take internally. Avoid contact with eyes. If solution does come in contact with eyes, flush immediately with water. For quickest removal from skin, wash with water before drying. KEEP OUT OF REACH OF CHILDREN.

FEATURES:

 Percent Solid: 50% by volume/64% by weight
Dry Times: 1 hr-touch / 4 hrs-recoat/ 7 days-full cure
Spread: 100 sq.ft ./ gal. = 12 to 14 mils wet; 6-7 mils dry
Flexibility: High performance elastomeric giving a minimum of 200%    elasticity
Viscosity: 150 KU / Density:11.62 lbs/gal.
UV-resistant
VOC: 82 grams / liter, or .69 lb. / gal.

LIMITED WARRANTY: 

 Unless the manufacturer provides a written warranty of fitness for a particular use, the manufacturer's sole warranty is that the product, as supplied, will meet then current sales specifications and is specific only to return of product found to be defective upon opening of container
within one year. Customer's exclusive remedy and Superior's sole liability for breach of warranty is limited to refund of the purchase price
or replacement of any product shown to be other than as warranted and
the manufacturer expressly disclaims any liability for incidental or consequential damages.

COVERAGE RECOMMENDATIONS:

Vertical walls 100 sq.ft. / gallon